Important Information - Product Care; Assembly - ALDI Workzone Titanium+ Xfinity Li-ION 20V YLW6281D Instruction Manual

10
6. Important information – Product care
NOTE: Xfinity Battery and Charger not included. For any issuses
related directly to your purchased ALDI Xfinity Battery / charger,
contact the Customer Service of the manufacturer as listed on the
battery / charger packaging, manual or on the label on the battery /
charger.
This 20V Wet & Dry Vacuum uses Lithium Ion Battery Cells. Care
MUST be taken to ensure both the safety and life of the pack is
maintained. Ensure you have read all of the safety notes in the
previous pages before using the 20V Wet & Dry Vacuum.
Treat the battery pack with care and within the guidelines of this
manual.
If the battery pack does become immersed in water or any fluids,
or is subject to a severe drop or it does not operate within the
guidelines of this manual or the supplied manual, immediately STOP
using the battery pack and have it checked.
Use only ALDI Xfinity Plus 20V range of batteries and chargers.

7. Assembly

WARNING! To prevent serious injury from accidental
operation, remove the battery pack and make sure that
On/Off switch is in "O" position while undertaking any assembly
or maintenance.
7.1 To remove and install the appliance head (5).
To remove:
1) Pull out the bottom of the side locking latch (7) to loosen the locked
part of the appliance head (5) from the tank (6) for one side. (See Fig. A1)
Then open the locking hook of the side locking latch (7). (See Fig. A2)
2) Release the other side with the same steps above.
3) Remove the appliance head (5).
To install:
1) Place the appliance head (5) on the tank (6) correctly. (See Fig. A3)
AFTER SALES SUPPORT
10
e-mail:
info.aldi@positecgroup.com
1300 889 028 (toll free)
MODEL No.:
YLW6281D • 700234 • 01/2020