Makita DCG140 Instruction Manual page 6

light up for a few seconds.
Indicator lamps
Lighted Off
NOTE: Depending on the conditions of use and the
ambient temperature, the indication may differ slightly
from the actual capacity.
Speed adjusting dial
1.
Higher speed is obtained when the dial is turned in the
direction of number 5, lower speed is obtained when it
is turned in the direction of number 1.
NOTE:
far as 5 and back to 1. Do not force it past 5 or
work.
ing material, it may not be fed at low speed. In
-
Remaining
capacity
Blinking
75% to 100%
50% to 75%
25% to 50%
0% to 25%
Charge the
battery.
may have
malfunctioned.
1
-
Overload warning lamp
1.
loaded. If the load reaches some point, the lamp keeps
release the trigger and pull the trigger again.
NOTE: Check what causes the overload when the
ter of the nozzle.
Switch action
CAUTION:
tool, always check to see that the switch trigger
position when released.
trigger in the OFF position.
B
1. Lock lever 2. Switch trigger
the trigger-lock button is provided.
increasing pressure on the switch trigger. Release the
switch trigger to stop.
6 ENGLISH
1
-
1
2
-
-
A