At+ Uuidchara2 Master Channel Characteristic Uuid; Hardware Design - Ebyte E104-BT40 User Manual

Chengdu Ebyte Electronic Technology Co.,Ltd.
2.Slave channel. Used to send data from the slave and the master to receive the data.
Example AT+UUIDCHARA1=65521, that is, the slave channel characteristic UUID value is set to 0xFFF1

6.4.33 AT+ UUIDCHARA2 MASTER CHANNEL Characteristic UUID

Setting
Parameter
Description 1.Restart takes effect, save when power off
2.Master channel. Used to send data from the master and the slave to receive data.
Example AT+UUIDCHARA2=65522, that is, the master channel characteristic UUID is set to 0xFFF2

7. Hardware design

It is recommended to use a DC stabilized power supply. The power supply ripple factor is as small as possible, and

the module needs to be reliably grounded;
Please pay attention to the correct connection of the positive and negative poles of the power supply. Reverse

connection may cause permanent damage to the module;
Please check the power supply to ensure it is within the recommended voltage otherwise when it exceeds the

maximum value the module will be permanently damaged;
Please check the stability of the power supply, the voltage can not be fluctuated frequently;

When designing current supply circuit, 30% margin is recommended to be remained so as to ensure long-term

stable operation of the whole module;
The module should be as far away as possible from the power supply, transformers, high-frequency wiring and other

parts with large electromagnetic interference;
High-frequency digital routing, high-frequency analog routing, and power routing must be avoided under the

module. If it is necessary to pass through the module, assume that the module is soldered to the Top Layer, and the
copper is spread on the Top Layer of the module contact part(well grounded), it must be close to the digital part of
the module and routed in the Bottom Layer;
Assuming the module is soldered or placed over the Top Layer, it is wrong to randomly route over the Bottom Layer

or other layers, which will affect the module's spurs and receiving sensitivity to varying degrees;
It is assumed that there are devices with large electromagnetic interference around the module that will greatly

affect the performance. It is recommended to keep them away from the module according to the strength of the
interference. If necessary, appropriate isolation and shielding can be done;
Assume that there are traces with large electromagnetic interference (high-frequency digital, high-frequency analog,

power traces) around the module that will greatly affect the performance of the module. It is recommended to stay
away from the module according to the strength of the interference. If necessary, appropriate isolation and shielding
can be done;
If the communication line uses level, 1k-5.1k resistor must be connected in series(not recommended, there is a risk

of damage)
Try to stay from some physical layers such as TTL protocol at 2.4GHz , for example: USB3.0;

Copyright ©2012–2019，Chengdu Ebyte Electronic Technology Co.,Ltd.
4-27
Command
AT+ UUIDCHARA2=[para]
Para(ASCII):UUID value. The value ranges from 1 to 65535, and each ASCII code ranges from 1 to 9.
E104-BT40 User Manual
Response
+OK:Success
+ERR=[NUM]：Error