Receiver Removal; Bracket Installation For Optional F45/60; Receiver (Gdi3) - Napoleon Oakville GDIG3 Installation Manual

fi nishing
EN
3.9

receiver removal

1. Remove the right access panel from the side of the
appliance.
2. Remove the front 2 screws from the inside edge (Fig.
3-5) and swing the control door open.
note:
If your opening is too small, you may need to
pull the appliance out slightly.
3. Remove the 2 screws holding the receiver in place.
4. Remove the receiver and replace.
3.10 bracket installation for optional F45/60 receiver (GDI3)
1. Remove the safety barrier and glass door (see "safety barrier & door removal / installation" section).
2. Remove the 1 screw holding the bracket in place (Fig. 3-6). Lift the bracket up and out of the slots, lifting it
through the opening between the fi rebox and the appliance's outer shell (Fig. 3-7).
3. Insert the optional receiver (F45 or F60) into the bracket. Secure the receiver using 2 screws (supplied).
4. Place the bracket and receiver back through the opening between the fi rebox and the appliance's outer shell.
Slide the bracket and receiver into and down the slots (Fig. 3-7 in reverse).
5. Resecure the 1 screw to hold the bracket and receiver in place (Fig. 3-6).
24
W415-1802 / D / 10.24.19
Outer Shell
Fig. 3-6
Fig. 3-5
Firebox
Fig. 3-7