ATTACK PELH30A Manual For Attendance page 28

Setting of photocell sensibility:
PHOTOSENSOR
ENTER < > EXIT
is installed. Pre-set from production is: 50%.
Selection of thermostat:
THERMOSTAT
ENTER < > EXIT
If you use burner thermal probe , it is possible to set 2 parameters. First, select starting
temperature, save value by pressing „M" button, then you can change stop temperature. By
repeated pressing of „M" you save also this value. Burner will now work in the range of the
actually set temperature values. There should be difference between starting and stop
temperature of at least 5°C.
Grate cleaning:
SCRAPER
ENTER < > EXIT
Language selection:
LANGUAGE
ENTER < > EXIT
Setting of output range:
EFFECT SPAN
ENTER < > EXIT
Adjustment of pellet dosing:
FEEDER ADJUST.
ENTER < > EXIT
sack and very exact weighing machine. After entering into parameter you have to set Heat
value (kWH/kg) as the first. Then, the text „Put on the sack" is displayed (pellet feeder
should be filled with pellets up to bore). Put the sack on the feeder and press the „M"
button.
Now check countdown on display, until feeder works for 6 minutes. Then enter weight of
fallen pellets by pressing „+" and „-" buttons and confirm/save by „M" button.
Ventilator setting:
VENTILATOR.
ENTER < > EXIT
Operation time of feeder:
Here you can set photocell sensibility, i.e. light value in
(%), to which should system react as to fire. It should not
be necessary to set the light sensibility, if correct photocell
Here you select required thermostat: external boiler
thermostat or burner thermal probe, or combination with
room thermostat.
By this parameter you can set, if the grate cleaning will be
activated and when it has to be turned on - before ignition
or after burn-down.
There is possibility to select these languages: Slovak,
English, German, Italian, French, Polish.
Burner can operate in the output range of 8 – 12 kW, or 14
– 30 kW, acoording to the range selected by this parameter.
= The most important parameter of the control system!
Here you set pellet ration supplied by feeder at full
operation. During setting of pellet ration you need plastic
By this parameter it is possible to adjust flue gas
adequately to flue gas analyzer for content of CO and O2
in flue gas.
27