Burner Start; Burner Stop; Emergency Stop - ATTACK PELH30A Manual For Attendance

Burner start

By turning the boiler´s main switch on is the burner automatically turned into emergency
regime. Burner is put into operation by turning the burner´s switch on and by turning
boiler´s thermostat into position adequate to required boiler temperature. Following
demand for heat supply is the burner ignited and burns pellets, until the thermostat gives
instruction to stop.
Burner is alternatively controled by thermal boiler sensor connected to TS1 inlet on the
right upper side of the circuit board. Make sure, that connection is fixed into one position.

Burner stop

Burner turnes off by turn-off-signal of the boiler thermostat, by turning off the burner´s
switch (emergency regime, or via Burn-down = Final combust. ) initiated per menu.

Emergency stop

NOTE:
In case of emergency can be burner turned off by the main boiler switch and by plugging-
out of the boiler´s mains cord from mains socket.
15