First Time Startup; Software Setup Sequence - Navico Simrad I3005 Operator's Manual

First time startup

When the unit is started for the first time, or after a reset, the unit
displays a series of dialogs. Respond to the dialog prompts to make
fundamental settings.
You can perform further setup and later change settings using the
system settings dialogs.

Software setup sequence

This chapter describes the software setup options as they appear in
the menu system.
All relevant areas listed must be addressed during commissioning,
and they should be stepped through in the listed sequence.
1
"Page settings" on page 25
• Define the pages that are to be used on this device
2
"Ethernet setup" on page 35
• Define this device on the Lightweight Ethernet
3
"Local port setup" on page 28
• Configure the two NMEA 0183 ports
• Configure the analog port
• Configure the digital port
4
"NMEA 2000 setup" on page 33
• Make sure that the global NMEA 2000 data sources have
been selected
5
"Display sources" on page 32
• Select sources for this device if these are to be different
from the global NMEA 2000 sources
When the required start-up settings are done, you should page
through all the remaining settings and confirm that they are as
desired.
Software setup | I3005/I3007 Operator Manual
23