Setup; Rain Gauge Setup - ACU-RITE 02446 Instruction Manual

SETUP

Rain Gauge Setup

Install or Replace Batteries
AcuRite recommends high quality alkaline batteries for the best product
performance. Heavy duty or rechargeable batteries are not recommended.
1
SQUEEZE
SQUEEZE TABS TO OPEN
1. Separate rain gauge cover from the base by gently
squeezing tabs and pulling the cover upwards.
2. Remove battery box by squeezing the two tabs on
each end together.
3. Remove and discard cardboard rain gauge stabilizer.
4. Insert 2 x AA batteries into the battery compartment
as shown. Follow the polarity (+/-) diagram in the
battery compartment.
5. Securely place the battery box back into the rain
gauge base.
6. Securely re-attach the rain gauge cover onto rain
gauge base.
Set the A-B-C Switch
Locate the A-B-C switch inside the
battery compartment. Set the A-B-C
switch to A, B or C. You must select
the same letter choices for both the
rain gauge and the display in order
for the units to synchronize.
A-B-C Switch
Set to match
display
2
SQUEEZE
LARGE
TAB
A B C
3
SQUEEZE
LARGE
TAB
5
4
5
6