Remote Control Setup 15; Putting Batteries In The Remote Control; Using The Remote Control - Philips DV910VHS98 Owner's Manual

DV910(H9100).QX33 01.8.9 10:26 AM

Putting Batteries in the Remote Control

1
Remove the battery compartment lid on the bottom of the
remote control by pressing the tab, then lifting the lid.
2
Place two AA batteries inside the battery compartment
with their + and – ends aligned as indicated.
3
Replace the battery compartment lid.

Using the Remote Control

Point the remote control at the DVD/VCR's remote sensor (see
page 26) when using the remote control to operate the
DVD/VCR.
Do not put objects between the remote control and the
DVD/VCR.
Recycling Guidelines/Battery Safety
Your new product and its packaging contain materials that can be
recycled and reused. Specialized companies can recycle your prod-
uct to increase the amount that needs to be properly disposed.
Your product uses batteries that should not be thrown away
when depleted but should be disposed of as small chemical waste.
Please find out about the local regulations on disposal of your old
product, batteries, and packaging whenever you replace existing
equipment.
Battery Usage CAUTION - To prevent battery leakage that may
result in bodily injury or damage to the unit:
Install ALL batteries correctly, with the + and - markings on the
battery aligned as indicated on the unit;
Do not mix batteries, for example, old with new or carbon with
alkaline; and
Remove batteries when the unit will not be used for a long
time.
Page 15

Remote Control Setup 15

1
2
3