Playing A Disc - Philips DV910VHS98 Owner's Manual

DV910(H9100).QX33 01.8.9 10:27 AM

50 Playing a Disc

DVD AUDIO CD
Before you begin, turn on the power of the TV, audio receiver
and any other equipment connected to the DVD/VCR. Make
sure the TV and the audio receiver (if applicable) are set to the
correct channel. Details are on pages 8-14.
1
Press the POWER button to turn on the DVD/VCR. "P-ON"
will appear briefly on the display panel.
2
Press the OUTPUT SELECT button so that the red DVD
OUTPUT light appears on the front of the DVD/VCR.
Then, press the DVD button.
3
Press the OPEN/CLOSE button on the front of the
DVD/VCR to open the Disc tray.
4
Place a Disc into the tray. Make sure the Disc is sitting proper-
ly in the correct recess.
Some DVDs are recorded on both sides. Make sure the side you
want to play is facing up. Or, if the DVD is recorded on only one
side, place the Disc in the tray with the label facing up.
5
Press the Play B button. The tray will close automatically, and
playback will begin at the first Chapter or Track of the Disc.
Or, you may press the OPEN/CLOSE button or press the tray
toward the DVD/VCR to close the tray; DVD playback will start
automatically.
If a DVD menu appears instead, details are on page 51.
With some Audio CDs, playback will not begin unless you press
the Play B button.
6
Press the Stop C button to stop playback. If disc playback is
stopped for more than five minutes, a screen saver will appear.
Details are on page 81.
Remember, this DVD/VCR
will play only certain Discs.
See page six for details.
Page 50
3
Press the OPEN/CLOSE button
on the DVD/VCR.
4
Insert a Disc.
POWER
MARKER
SETUP AUDIO SUBTITLE ANGLE
MENU TITLE
OK
MODE RETURN
2
OUTPUT SELECT
DVD VCR
SKIP/CHANNEL CHANNEL/SKIP
H/ L K /G
B
6
E D
C
REC
F
/OTR
A-B
CLEAR
REPEAT
Helpful Hints
• An "X" may appear at the top right
corner of the TV screen when you
try a feature. Either the feature is
not available on the Disc, or the
DVD/VCR can not access the fea-
ture at this time.This does not indi-
cate a problem with the DVD/VCR.
• If a Disc is dirty or scratched, the
pictures may appear distorted and
playback may stop. Remove the
Disc and turn off the DVD/VCR.
Disconnect the power cord, then
reconnect it. Clean the Disc, then
turn on the DVD/VCR again and
reinsert the Disc for playback.
• When the DVD or CD light appears
on the display panel, the Disc is
loaded completely and is ready for
playback.
• When you press the OPEN/CLOSE
button or the DVD PLAY button on
the front of the DVD/VCR when the
power is off, the DVD/VCR will turn
on automatically and will be in DVD
mode.
1
5