Table of Contents
Advertisement
Quick Links
RRDCD INSTALLATION CARD
Before you install a second RRDCD CD-ROM tray in a
Compaq AlphaServer GS60E system, the system must
contain two PCI card cages, each connected to a separate
KFTHA (for logical partitions), and each with a KZPBA
adapter installed. See the figure below.
Front
First
CD-ROM
Housing
Second PCI
card cage
adapters
You must also have a BN21H-02 cable on hand, to connect
the KZPBA in the second PCI card cage to the second CD-
ROM. If you have these, proceed with the installation.
© Compaq Computer Corporation 1999.
All rights reserved.
EK–RRDXX–IN. B01
Rear
KZPBA
CB1
CB1
CB2 CB3 CB4
CB2 CB3 CB4
CB5 CB6 CB7 CB8 CB9 CB10 CB11
CB5 CB6 CB7 CB8 CB9 CB10 CB11
BX-0183Mf-99
1
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Compaq RRDCD
Summary of Contents for Compaq RRDCD
- Page 1 EK–RRDXX–IN. B01 RRDCD INSTALLATION CARD Before you install a second RRDCD CD-ROM tray in a Compaq AlphaServer GS60E system, the system must contain two PCI card cages, each connected to a separate KFTHA (for logical partitions), and each with a KZPBA adapter installed.
- Page 2 Push mount for 90-07867-00 cable tie Cable tie 90-07032-01 RRDCD Installation EK–RRDXX–IN Card 2. Shut down the operating system and remove power from the system, by turning the keyswitch to Off. 3. Open the front door of the system. Lift the top panel of the system ( ).
- Page 3 4. Ground yourself to the cabinet with the antistatic wrist strap at the front of the system. 5. Insert the key buttons (74-23357-01) into holes 38 and 32 of the vertical rail and screw on the fasteners (90- 08203-00) until the key buttons are tight against the rail (see 6.
- Page 4 8. Detach the power cable from the top CD-ROM tray. Front CD-ROM power cable BX-0183Ua-99 9. Attach the single end of the cable splitter (17-04965- 01) to the end of cable you just detached. 17-04965-01 BX-0183Ub-99 10. Connect power cable to the top and bottom trays. BX-0183Ud-99...
- Page 5 11. At the left side of the system (side panel removed) insert push mounts for the cable tie wraps in hole 42 of the front and back side rails. (See in the figure below). 12. Route the BN21H-02 cable from the KZPBA in the lower PCI card cage ( ) to the second CD-ROM tray directly below the terminator ( ).
- Page 6 13. Close the cabinet doors, and turn the system keyswitch to On to power up the system. After power-up, issue a show device command to check that the two CD-ROMs are properly connected (see and , below). P00>>> sho dev polling for units on floppy0, slot 0, bus 1, hose0...
Need help?
Do you have a question about the RRDCD and is the answer not in the manual?
Questions and answers