Checking For Faults - SIGMA SPORT BC 700 Short Instruction Manual

• 12. CHECKING FOR FAULTS [Qg|
If in the DST display all figures show zero and DST and first zero are (lashing:
— The power supply has been interrupted due to severe jarring. Remove batteries, check
contacts, clean if nocossary and re-enter the total distance, wheel circumference and time.
If there is no speed display:
— Check that the cycle computer is properly engaged in the bracket.
— Check the distance and the position of the magnet in relation to the sensor.
— Check the contacts of the cycle computer and the bracket. Clean and bend contacts into po-
sition If necessary.
— Check the cable for damage.
Extreme températures (above 60°C) can result in a blackening of the LCD display.
This does not impair the operation of the cycle computer. Once cooled down, the display returns
to normal.
At temperatures below freezing the display can become sluggish. This does not affect the
operation of the computer and the display will return to normal when temperatures rise.