Re-Setting The Total Distance - SIGMA SPORT BC 700 Short Instruction Manual

ing Attention: Make a note of the total distance and wheel size (see wheel size setting)
so that they can be re-entered afterwards.
Remove both screws Irom the battary compartment cover and remove cover (fig. 20).
Change the batteries, observing plus and minus (fig. 21).
Insert the seal (fig. 22), replace the battery compartment cover and tighten both screws (fig. 20).
NB: After you have closed the battery compartment, the computer will automatically prompt you
to re-enter total distance.
• 11. RE-SETTING THE TOTAL DISTANCE (Figs. 23-24)
The total distance can only be entered following a battery change.
Following a battery change, DST and tho first figure of the total distance are shown flashing on
the display.
Note: The figures must be entered in the correct position (e.g. for 680 km enter 00680) (Fig. 24).
Pressing button (A) advances the flashing figure by one number at a time, until the required
figure is reached).
Press button (B) to store the required figure (fig. 23). The next figure to be entered starts to flash
and can be set using button (A).
Once the last figure has been set, you have to choose the first figure again by pressing button B
Once the total distance is set, press the grey button on the back of the computer (fig. 13).
NB: After the total distance has been set, the wheel size and the time has to be re-entered again-