Front Panel Removal - ELNA eXcellence 740 Replacement Manual

Front Panel Removal

1. Open the left side of the machine and locate
the small phillip's head screw that is holding
the front panel to the casting. Just loosen this
screw.
2. At the upper right hand side of the front
panel there is a phillip's head screw that
needs to be loosened.
3. Looking through the right hand
side of the machine there is a screw
that is in the inside and this phillip's
head
loosened as well.
(Picture shown with base plate
removed , but you can loose the
screws
attached)
3
screw just needs
with the base
to be
plate