Belt Cover Removal - ELNA eXcellence 740 Replacement Manual

Belt Cover Removal

1. Lift the handle up and locate the
small philip's head screw on the right
hand side at the top of the belt cover.
Just loosen this screw.
3. Gently lay the machine down on it's
back and locate the two phillip's head
screws that are holding the bottom part
of the bed cover to the casting. Just
loosen these screws.
(* Two loosen the two screws, you do
not need to remove the base plate!)
2. Look at the right side of the
machine and locate the philip's head
screw a couple of inches below the
hand wheel and remove the screw
completely.
4. Stand the machine up and grab the
top of the belt cover from the rear and
start to pull it towards the front of the
machine. Release the belt cover from
the front panel and remove completely.
2