Husqvarna RA850 Workshop Manual page 14

a) Do the same procedure for the remaining 5
puller hooks.
15. Attach the 6 puller hooks to the holder with the 6
Servicing tools on page 8 .
screws. Refer to
16. Put the bolt in the holder. Refer to
page 8 .
14 - Repair instructions
17. Hold the holder (A) with a wrench and tighten the
18. Remove the lower arm and the special tool.
19. Remove the snap ring.
Servicing tools on
20. Pull out the shaft.
bolt (B) until the lower arm is loose.
B
A
1048 - 002 - 18.09.2019