Husqvarna RA850 Workshop Manual page 13

9. Remove the lower connecting rod.
10. Remove the gear.
11. Remove the spacer (H) and the shaft (I).
1048 - 002 - 18.09.2019
I
H
12. Put the pin on the shaft. Refer to
page 8 .
13. Put the holder on the lower arm. Refer to
tools on page 8 .
14. Put 1 puller hook at a time below the lower arm.
Move the puller hook around the holder until the
puller hook aligns with a hole in the holder. Refer to
Servicing tools on page 8 .
Servicing tools on
Servicing
Repair instructions - 13