Philips HR4345/00 Operating Instructions Manual page 8

35
Removing the filters
37
- Switch the appliance off (fig.
35).
- Remove the front cover with
the pre-filter (fig. 36).
Please note: Do not push
against the control panel
when pulling off the front
cover (fig. 37).
- Remove the Hepa filter
(fig. 38).
- Remove the Carbon filters
(fig. 39).
- To place the filters back
reverse this process.
Safety lock
The front grill has a safety lock.
This lock switches the motor off if the cover is removed while
40
the Air Cleaner is still switched on.
Cleaning the Pre-filter
36
38
39
41
- Wash (fig. 40) or vacuum
clean the Pre-filter. You can
remove fluff or hairs e.g. using
a soft brush.
- If washed with a detergent,
rinse the filter with clean warm
water (fig. 41).
- Allow the filters to air-dry
thoroughly (fig. 42) before
reassembly.
Replacing the Hepa filter
Remove and replace the Hepa filter every second time when
you replace the Carbon filter granules.
New Hepa filters are available at your dealer under number
HR 4940.
Replacing the Carbon filters granules
• Remove and replace the Carbon filters when the Carbon
filter replacement indicator (Q) starts flashing (firstly) or is on
43
continuously (later).
Do not forget to reset the indicator when ready. (See
"Resetting the Carbon filter replacement indicator".)
45
• New carbon granules are available at your dealer under
number HR 4941.
47
- Carefully remove the lid (fig. 43).
- Tip out the foam screen and the old carbon granules into a
disposal bin (fig. 44).
8
yyyyy
yyyyy
42
yyyyy
yyyyy
yyyyy
yyyyy
44
46
48