Advertisement
The snaptite assembly system locks end channels to all roof and wall sheets without
the need for tools and fasteners.
PUSH
TIP: Position sheets on timbers,
trestles or partly over edge of
concrete slab.
FASTENING SYMBOLS
D
Join components together by pre-drilling the holes first.
Use one component as a template to mark where the
holes are. Drill with 3mm drill bit.
Join components together with one screw at this
location only, as some channel sections have extra
holes that are not required for this model of garden
shed
Do not join components together at this location yet,
as the screw may obstruct further assembly of other
components
ABSCO INDUSTRIES
Bin Cover Model: 1508BCK
SNAPTiTE ASSEMBLY GUIDE
To assemble each panel, the perimeter
channels are secured to the top and
bottom of each panel using the snaptite
system, as detailed on the following
pages wherever you see this symbol.
SNAP
After fastening sheets together, position the channel over one end of the sheets.
Gently tap it over the SNAPTiTE lugs, working along the sheets to the other end.
PUSH
ASSEMBLY INSTRUCTION MANUAL
Absco Industries
T TE
i
Each perimeter channel must finish flush with the
edges of the sheets.The snaptite system allows
adjustment for this process by simply tapping the
channel along the sheets until each end is neatly
flush. If you need to remove channels from the
panels, pull the channel along the panel from
opposing ends. You may need someone to help
with this.
SHED MODEL: 1508BCK
3mm POP RIVETS
4mm NUT & BOLT SET
11-04-2018
PAGE 08
Advertisement
