1.
Remove the oil fill cap.
a
2.
Add engine oil to bring the level up to, but not over, the FULL or OK range mark on the dipstick. Check the oil level.
3.
Replace the fill cap.
Models
Engine oil (with filter)
Changing Oil and Filter
Refer to the Maintenance Schedule for the change interval. Engine oil should be changed before placing the boat in storage.
IMPORTANT: Change engine oil when the engine is warm from operation. Warm oil flows more freely, carrying away more
impurities. Use only recommended engine oil (refer to Specifications).
Easy Engine Oil Drain System
NOTE: Boat must be out of the water to perform this procedure.
1.
Loosen the oil filter to vent the system.
2.
Remove the bilge drain plug.
3.
Pull the tether through the bilge drain.
a
a -
Bilge drain plug
b -
Tether
c -
Clip
d -
Oil drain hose plug
e -
Oil drain hose
f -
Bilge drain flange
90-8M0086943
DECEMBER 2014
eng
4.25 L (4.5 US qt)
c
b
a -
Oil fill cap
6077
Capacity
Mercury/Quicksilver 25W‑40 Synthetic Blend
Engine Oil, NMMA FC‑W Catalyst Compatible
d
Section 5 - Maintenance
Fluid Type
rated
e
f
7284
Page 45