KVH Industries TracVision UHD7 Installation Manual page 18

12 Continued
DIRECTV – SWM Wiring
Follow these steps to connect DIRECTV receivers
to the TracVision system.
Connecting 1 SWM Receiver/DVR
Connect an RF cable from the "Signal to IRD"
connector on the SWM power inserter to the
"Satellite In" jack on the receiver (see Figure 25).
Connecting Up to 8 SWM Receivers (13 Tuners Max)
a. Connect an RF cable from the "Signal to IRD"
connector on the SWM power inserter to the
"SWM" input on an 8-way SWM splitter (see
Figure 26).
b. Connect the SWM splitter's outputs to the
"Satellite In" jack on the receivers/DVRs (or
"Network" jack when connecting a Genie
client). You can connect up to 8 SWM devices
that add up to 13 or fewer tuners. Refer to
Figure 26 to determine the tuners consumed by
each type of device.
NOTE: HR34 and HR44 Genies both reserve 5 tuners.
The HR54 Genie reserves 7 tuners.
c. Terminate any unused outputs on the splitter
with 75terminators and tighten with a
7/16" torque wrench set to 20 in.-lbs.
16
Wire the Receivers
Figure 25: Wiring 1 DIRECTV Receiver
Deck
TV-Hub
SWM Power
Inserter
AC Power
Figure 26: Wiring Up to 8 DIRECTV Receivers
SWM Power
Inserter
AC Power
Terminate
unused
outputs
Note: Connect any combination of receivers, DVRs, and
Genie clients that add up to 13 or fewer tuners on the
RF2 cable. Only 3 Genie clients can be active at one time.
Antenna
RF1
Grounding
Block
Antenna
POWER
TO SWM
SIGNAL
Satellite In
TO IRD
POWER
TO SWM
SIGNAL
TO IRD
Supports up to 13 tuners:
Each SWM receiver = 1 tuner
SWM Splitter
Each SWM DVR = 2 tuners
Each Genie DVR = 5 or 7 tuners
Each Genie client = 0 tuners
Satellite In
Satellite In
Network
AC Power
RF2
SWM Receiver
AC Power
SWM Receiver/DVR
AC Power
Genie DVR
COMPONENT VIDEO OUT
Y Pb Pr
DIGITAL
AUDIO OUT
SATELLITE IN 1
POWER INPUT
L R
IR RECEIVE ETHERNET VIDEO OUT AUDIO OUT S-VIDEO OUT SATA HDMI USB PHONE JACK
AC Power
Genie Client