KVH Industries TracVision UHD7 Quick Start Manual

How to Turn On the System

TV-Hub
Power Switch

How to Access the Web Interface

IP address (wireless):
172.16.0.1
TV-Hub
IP address (wired direct):
169.254.253.1

How to Select a Satellite

©2019 KVH Industries, Inc., All rights reserved. KVH, TracVision, and the unique light-colored dome with dark contrasting baseplate (Reg. No. 2,864,752) are registered trademarks of
KVH Industries, Inc. All other trademarks are the property of their respective companies. The information in this document is subject to change without notice.
TracVision
This guide provides basic operation and troubleshooting information for the TracVision
UHD7 satellite TV antenna system. For complete operation, setup, and diagnostics
information, refer to the system's comprehensive Help Center, available on the TV-Hub's
web interface. If you need any assistance, please contact KVH Technical Support.

Technical Support

North/South America, Australasia:
Phone: +1 401 847-3327
Email: support@kvh.com
At the rear panel of the TV-Hub, set the power switch to the On
position. The TV-Hub supplies power to the antenna. Wait a
few minutes for system startup.
If the TV-Hub's status lights alternate orange, it is synchronizing
software. Do not turn off the system. It could take 40 minutes.
You can access the web interface using any Wi-Fi-enabled
KVH TracVision
TV-series/UHD7/ mobile device (such as a smartphone, tablet, or laptop).
RV1/A9 app:
1. Select the TVHub-<TV-Hub serial number> network from
Download the
free app to an
Apple iOS
®
or Android
™
2. Either start your web browser and enter http://tvhub.kvh,
tablet or
smartphone
If the TV-Hub is connected to an onboard network, you may also
access the web interface over the network by entering the
TV-Hub's IP address either in your browser or in the TracVision
app. (You can find the IP address on the Settings page of the
web interface or app.)
KVH recommends that you run the Setup Wizard whenever you
need to change the configuration of your system, but you can
also manually select a satellite by following these simple steps.
1. On the Satellites page, set Satellite Mode to Single.
2. Find the desired satellite in the list and select it by setting
No company shall be liable for errors contained herein. 54-1310 Rev. A
UHD7 Quick Start Guide
®
Europe, Middle East, Africa, Asia-Pacific:
Phone: +45 45 160 180
Email: support@emea.kvh.com
your device's Wi-Fi settings to connect to the TV-Hub.
or open the KVH TracVision TV-series/UHD7/RV1/A9 app.
a checkmark under the Selected column. You can filter
the list by name, orbital slot, or region by clicking the
associated header.