Lexus UX 200 Owner's Manual page 207

206
4-3. Operating the lights and wipers
6
Increases the sensitivity
7
Decreases the sensitivity
8
Washer/wiper dual opera-
tion
Pulling the lever operates the wipers and
washer.
The wipers will automatically operate a
couple of times after the washer squirts.
(After operating several times, the wipers
operate once more time after a short delay
to prevent dripping. However, the dripping
prevention does not operate while the
vehicle is moving.)
Vehicles with headlight cleaners: When the
engine switch is in ON and the headlights
are on, if the lever is pulled, the headlight
cleaners will operate once. After this, the
headlight cleaners will operate every 5th
time the lever is pulled.
The windshield wipers and washer can
■
be operated when
The engine switch is in ON.
Dripping prevention wiper sweep (vehi-
■
cles with rain-sensing windshield wip-
ers)
After washing and wiping operation several
times, the wipers operate one more time
after a short delay to prevent dripping.
However, this function will not operate while
driving.
■ Effects of vehicle speed on wiper opera-
tion (vehicles with rain-sensing wind-
shield wipers)
Vehicle speed affects the intermittent wiper
interval.
Raindrop sensor (vehicles with rain-
■
sensing windshield wipers)
● The raindrop sensor judges the amount
of raindrops.
An optical sensor is adopted. It may not
operate properly when sunlight from the
rising or setting of the sun intermittently
strikes the windshield, or if bugs, etc. are
present on the windshield.
If the wiper switch is turned to the AUTO
●
position while the engine switch is in ON,
the wipers will operate once to show that
AUTO mode is activated.
If the temperature of the raindrop sensor
●
is 90°C (194°F) or higher, or -15°C (5°F)
or lower, automatic operation may not
occur. In this case, operate the wipers in
any mode other than AUTO mode.
If no windshield washer fluid sprays
■
Check that the washer nozzles are not
blocked, if there is washer fluid in the
washer fluid tank.