Philips SBCRU530/88 User Manual page 5

Instructions for use
7
– The green LED flashes twice.
C
Switch equipment on manually. Press a few keys to check correct
response. If response is not correct, repeat procedure beginning
at step 1.
N
- The search time averages about 90 seconds. (Maximum search
time is 5 minutes for TV, 2 minutes for VCR and 4 minutes for
SAT).
- Autosearch stops automatically after all codes have been
tested.
MAKE A NOTE OF YOUR CODE!
A
Carefully read the complete procedure before starting!
Note the code inside the battery case and in the codelist in
the centre of this booklet. This may be useful if you ever need
to set up the SBC RU530 again. You used the auto search
procedure or you forgot to note the code after set up? No
TV VCR SAT
problem! You can still 'read out' the code from the remote:
1
2
1 6
– The green LED lights up.
3
– The green LED goes out.
4
1
5
2
6
3
7
4
8
Press the power key to lock the correct code in the SBC
RU530's memory.
H E C K
O T E
D V I C E
Make sure you've selected the right mode with the mode
selector key.
Press and release keys 1 and 6 simultaneously.
Important: after pressing the keys, you have to release them
immediately!
Press the two digits key.
Press key 1 and count the number of times the green LED
flashes. This is the first digit of the 4-digit code. (No
flashes means the digit is zero.)
Press key 2 and count the number of flashes for the second
digit.
Press key 3 and count the number of flashes for the third
digit.
Press key 4 and count the number of flashes for the forth
digit.
Note the code.
5