Philips SBCRU530/88 User Manual page 4

Instructions for use
Your equipment is of another brand, or your
equipment is a Philips brand, but not all keys
respond correctly:
TV VCR SAT
1
2
3
4
1 3
5
0 - 9
– The green LED flashes twice.
C
That's it! Press a few keys to check correct response. If
response is not correct, repeat procedure beginning at step 1,
using the next 4-digit code from the codelist.
N
- If the LED displays one long flash, the code was not
recognised. Please go back to step 1 and repeat the
procedure, using the next 4-digit code in the list.
- If no key is pressed within 30 seconds, you have to start
again at step 1.
- If no correct code is in the list, go to the next paragraph.
You do not know the brand of your
equipment/you can not find the right code in
the code list » auto search:
TV VCR SAT
1
2
3
1 3
4
Press the power key to start the search. Make sure that
you keep the remote control pointed at your equipment.
– Each time the green LED flashes, another code is sent.
5
Switch the equipment manually back on.
6
Press 'PROG-' (down only!) repeatedly to send previous
PROG
codes until the equipment switches off again.
4
Press the mode selector key to select the device (TV, VCR
or SAT) you want to operate.
Look up the brand name of the device you want to
operate in the code list (centre of this manual).
Make sure you choose the correct code list for your device!
Make sure the device is switched on.
Press and hold keys 1 and 3 simultaneously - for about
three seconds- until the green LED lights up. (Release the
keys: the green LED should stay on)
Enter your 4-digit code using the number keys, within
30 seconds.
H E C K
O T E
Press the mode selector key to select the device (TV, VCR
or SAT) you want to operate.
Make sure the device is switched on (if the device is a
VCR, please insert a tape and start playback).
Press and hold keys 1 and 3 simultaneously -for about
three seconds- until the green LED lights up.
(Release the keys: the green LED should stay on)
When the right code is found, the equipment switches off
(VCR stops playback). Immediately press the power key to
stop the search.
If the green LED flashed again after the equipment
switched off, this means you missed the correct code!
If you missed the code, follow the next procedure, starting
at step 5. If the LED did not flash again after the
equipment switched off, go to step 7.