Machine With Drain Pump; Machine Without Drain Pump - Whirlpool EVO Series Instruction Manual

6.2 DRAIN
9

MACHINE WITH DRAIN PUMP

Without the overflow pipe
To switch the machine off, press this symbol for 2 seconds
.
"DISCHARGE TANK – P – TO STOP" will appear on the
display (in the case of automatic discharging).
If this button is pressed within 20 seconds, the tank
will not be discharged, otherwise it will be discharged
automatically.
Upon completion, "OFF" appears on the display.
NB: If the machine is left in stand-by (OFF on display) for
more than 3 hours with the tank full, the clean water cycle
will start. The tank will be discharged automatically and will
be filled with clean water.
MACHINE WITH DRAIN PUMP
With overflow pipe
To switch the machine off, press this symbol for 2 seconds
. "REMOVE OVERFLOW" will appear on the display
for 20 seconds; open the door and remove the overflow.
"OFF" will appear on the display when the drain phase in
over.

MACHINE WITHOUT DRAIN PUMP

With overflow pipe
To switch the machine off, press this symbol for 2 seconds
. "REMOVE OVERFLOW" will appear on the display
for 20 seconds; open the door and remove the overflow.
"OFF" will appear on the display when the drain phase in
over.
In the versions with CVC (steam recovery) and HY-NRG, at
the end of the discharge phase, an automatic cleaning
cycle of the CVC line and of the tank will start, lasting 1.5
minutes. "Autoclean - discharge" appears on the display.
Upon completion, "OFF" appears on the display.
The versions with break tank can also discharge the boiler:
during the discharge phase, press this button
"discharge tank / discharge boiler" will appear on the
display.
Note: With the machine discharged, after unplugging it
from the mains socket on the wall and shutting-off the
mains on/off tap, remove the filters, wash the inside of
the tank and the filters with suitable products, then put
the filters back in the tank.
and