Table of Contents
Advertisement
Quark-elec Manual
1. Setup Overview
1.1. Before leaving home:
Drivers and Configuration software are optional and only needed for specific features. The
Configuration Software and specific instructions are included on the FREE CD and as a download from
www.quark-elec.com.
Consider if there is a CD reader/internet access on site, if you will use the features below.
Accessing data on a Mac/Linux/Windows PC
Driver required if using Windows and should install automatically, if not, it is included on the free
CD and at Quark-elec.com. Drivers not required for Mac or Linux.
12.0V power from N2K bus
Connecting wirelessly to the A032 through Station mode WiFi (through a router, not just peer-to-
peer directly from the device)
Configuration software (Windows PC Required). Driver may be required as above
12.0V power from N2K bus
Adjusting NMEA 0183 baud rates. The NMEA 0183 baud rates are set to different settings
depending on the A032 version (A032-S: 4800bps / A032-AIS: 38400bps). These are simply the
default setting; users can adjust the baud rates using the Configuration software.
Configuration software (Windows PC Required). Driver may be required as above
12.0V power from N2K bus
1.2. Installation and Setup
1. Mounting: Consider the location...
Dry, sturdy location 0.5m from other WiFi equipment.
Ensure there is the correct length of wires needed. If drilling holes for cabling, seal around any holes
to prevent damage to the vessel or equipment. Keep USB dust cover on if USB is not used
2. Connect to the NMEA 2000 backbone (12.0V power)
The A032 draws 12.0V power from the NMEA 2000 backbone. Users will need an N2K backbone and 2
termination resistors (1 on each end).
3. Connect the NMEA 0183 device following the colour code below
4. Check LED lights are working on the A032.
Power: Top LED (red) flashes at 3 second intervals.
NMEA 2000 input: Middle LED flashes for each valid message received.
NMEA 0183 input: Bottom LED flashes for each valid message received
Please note: the NMEA LEDs will flash when their respective data is received, not sent.
https://www.quark-elec.com
V4.0
Wire Colour
Wire Function
Blue
White
Black
Grey
Brown
3 of 22
NMEA out-
NMEA out+
NMEA in-
NMEA in+
GND
.
2019
Advertisement
Table of Contents
