Download Print this page

Ubiquiti PAK-620 Quick Start Manual

Precision aligment kit

Precision Alignment Kit for

620 mm Dish Reflector

Model: PAK-620

Table of Contents

Need help?

Do you have a question about the PAK-620 and is the answer not in the manual?

Page 1 Precision Alignment Kit for 620 mm Dish Reflector Model: PAK-620...
Page 2: Package Contents
Introduction Thank you for purchasing the Ubiquiti Networks® Precision Alignment Kit, which is compatible with the following: • airFiber® AF‑5G30‑S45 • PowerBeam PBE‑5AC‑620 ™ • PowerBeam PBE‑M5‑620 • RocketDish RD‑5G30‑LW ™ Package Contents Alignment Bracket Pole Clamps Carriage Bolts Assembly (Qty. 2) (M8x150, Qty.
Page 3 Hardware Overview Elevation Lever Elevation Adjustment Screw Elevation Alignment Bracket Azimuth Adjustment Screw Azimuth Alignment Bracket Alignment Bracket Assembly after Separation of Brackets...
Page 4 Installation The following instructions show the RD‑5G30‑LW; however, they also apply to other antennas that use 620 mm dish reflectors. 1. Loosen the four hex head bolts of the Alignment Bracket Assembly. 2. Lift the Elevation Alignment Bracket up and out to separate it from the Azimuth Alignment Bracket.
Page 5 3. Use four Hex Head Bolts to attach the Elevation Alignment Bracket to the antenna. Ensure that the Hex Head Bolts go through the Elevation Levers on the inner sides of the Elevation Alignment Bracket. 4. Attach two Pole Clamps to the Azimuth Alignment Bracket. a.