Qualcast QHTLi40 Instruction Manual page 27

Cleaning the Saw Body
Chain and chain bar assembly (continued)
5. Check if all parts are seated properly and hold the chain and guide bar in a level
position. (See Fig. D)
tighten
6. Fit the cover plate, ensure that the guide wheel
12
cover plate . (See Fig. A)
7. Tighten the chain cover by turning the chain-locking knob
close to fully tight (half or one cycle away to the most), (See Fig. E) and then tighten
the chain-tensioning knob
again to the most.
WARNING: The chain is not yet tensioned. Tensioning the chain applies
as described under 'TENSIONING CHAIN'. The chain now needs to be
inspected to make sure it is properly tensioned.
26
D
12 clockwise before tightening the chain-locking knob
E
18
fits into the groove of the
11 clockwise until it is
tighten
11