Chain Brake; Stopping The Chainsaw - Qualcast QHTLi40 Instruction Manual

Operation

Chain brake

2. CHAIN BRAKE (See Fig. J)
WARNING! Check the voltage and current supply. The voltage and current
supply must comply with the ratings on the type plate.
WARNING! Ensure the extension cord is of the proper size and type for
your saw ( ≥ 1.5mm
Make sure the chain brake lever is disengaged. The motor will not start if the
chain brake is in the engaged position. Disengage the chain brake lever by
pulling backward towards the front handle.
Grip the product with both hands, left hand holding the front handle (do not hold the
chain brake) and the right hand holding the rear handle. Press the lock-off button (3),
then fully press the switch trigger (2) and hold in this position. The lock-off button
can be released now.
NOTE: It is not necessary to maintain pressure on the lock-off button once the
switch trigger is squeezed and the motor is running. The lock-off button is a safety
device to avoid accidental starting.

Stopping the chainsaw

3. TO STOP THE CHAINSAW
- Release the trigger On/Off to stop the machine.
- The chain stops completely after a few seconds.
- Disconnect the plug at source for safety.
- When the machine has cooled down for several minutes, it is advised to put on
the blade protection cover for longer storage.
2
)
Disengage
J
17