Table of Contents
Advertisement
Wearing the Product
2. Wearing the controller
➡ "Wearing the Controller" p. 9
3. Turning on
➡ "Turning On and Off" p. 8
Check that the power indicator on the product is light blue (turned
on).
4. Wearing the headset
Since the weight of the headset makes it easy for the helmet to slip
forwards, make sure the helmet is firmly secured to your head.
Caution
When the lens is lowered, your field of vision is narrowed even when
nothing is displayed. When not viewing images, make sure you slide up
the lens for your own safety.
Note
The headset can be worn over glasses that are up to 143 mm wide.
A
Put on the helmet.
Secure the chin strap and the adjuster so that the helmet does
not slip off while you are working.
B
Lower the lens below the brim of the helmet.
If the lens bumps the brim of the helmet when you lower it, you
need to attach the headset again.
➡ "1. Securing the headset to the helmet" p. 13
C
Adjust the position of the head pad so that the im-
age is displayed in the correct position in the lens.
Raise and lower the lens and adjust so that it does not hit the
brim of the helmet.
14
Note
If the lens is below eye level and you cannot see the images, use
the dedicated helmet inner cap.
D
If you cannot view a part or any of the image, adjust
the lens justifier on either side of the lens.
Adjust the left and right by the same amount so that the lens
is not tilted.
If you still cannot view images even after adjusting the lens
justifier, start again from step C.
E
Check that you can slide up the lens and secure
visibility.
If visibility cannot be secured when sliding up the lens, or if
you cannot raise the lens, start again from step A.
Caution
To prevent the headset from being dropped while removing the hel-
met, hold the head pad in one hand while removing the helmet.
Replacing the Rubber Band (BT-2200)
If the headset's rubber band deteriorates, replace it with a new
rubber band.
A
With the rubber folded in half, route it through the
adjuster.
Make sure you route the rubber through the uneven side at
the back of the adjuster.
B
Route the rubber through the gap in the center of
the adjuster.
Pull the leading edge of the folded over rubber band to the
helmet side (inner round section).
Advertisement
Table of Contents
