Wearing The Product - Epson MOVERIO Pro BT-2200 User Manual

Wearing the Product

For the BT-2200 you need to secure the headset to the helmet before wearing.
➡ "Supported Helmet Sizes" p. 11
Warning Product usage precautions
Make sure you check that the following items each time you use this product.
The lens should stop at the
position to which it is raised
When the lens is raised, it
should not strike the brim Secure the four helmet holders to
of the helmet the helmet
If you notice any problems with any of these items, do not use the product as when it cannot be secured safely, it could cause an accident or injury.
Also, make sure you replace any consumable items if they are damaged or worn.
• Before operating this product, make sure it can be worn according to the procedures in "Wearing the Controller" p. 9 as well as on this page and the following pages.
• As much as possible, make sure that the cables are secured to your body and do not sag or droop. If the cables come loose, they could get caught
or entangled in something and cause an accident or injury.
1. Securing the headset to the helmet
A
Adjust the length of the rubber band according to
the size of the helmet.
Adjust so that there is no slack in the rubber band.
B
Attach the helmet holders to the rubber band.
Attach two at the front (where the rubber is doubled), and
two at the back.
Caution
Make sure the helmet holders are facing the right way.
C
With the head pad stuck to the front of the helmet, se-
cure the rubber band at the lower part of the helmet.
Caution
• Adjust the headset so that it is aligned with the centerline of the
helmet.
• Route the cable over the top of the rubber band.
Note
Due to the characteristics of the material of the rubber band, the
color of the band may rub off on the helmet.
When cleaning, see the cleaning method recommended for the helmet.
Route the cable through two
points in the helmet holders
The cable comes
out at the back
D
Attach the four helmet holders to the helmet.
Caution
Make sure you attach the helmet holders in positions where they
do not damage the protective material inside the helmet.
E
Route the cables through the helmet holders (two
points) and out the back of the helmet.
Caution
• Make sure the cable is not damaged when you pass it through
the helmet holders.
• When the headset is attached to the helmet, do not subject it to
powerful shocks.
• When you are not wearing the helmet, place it on a table or a
workbench and so on. If the helmet is hung on a hook on a wall
and so on, the headset may fall off and be damaged.
The helmet holder, band holder,
and adjuster should not be dam-
aged, cracked, or deformed
The rubber band
should not be slack
The rubber band
should not be cut,
cracked, split, or dirty
13