Safety Instructions..........3 Troubleshooting ............13 Part Names and Functions ......6 Specifications ............14 Getting Ready ............8 Intellectual Property Rights ......15 Turning On and Off ..........10 General Notes ............15 Wearing the Product ..........10 Contact List ..............18 Copyright© 2015 Seiko Epson Corporation. All rights reserved.
Included Items Headset Inner pads (A/B/C) Wear the headset to view images. Attach inside the headset to adjust the ➡ “Wearing the Headset” p. 11 headset to fit your head. The inner pad B is attached to the headset at the time of purchase.
Safety Instructions For your safety, read the attached documents carefully to use the product correctly. After you have read the documents, save them for later reference. Safety symbols General information symbols Indicates procedures which may result in damage Caution This symbol indicates information that, if ig- or injury if sufficient care is not taken.
In the following situations, turn off this product immediately, unplug the power plug, and contact your local dealer or the Epson service call If the batteries are not handled correctly, the battery could explode or center. Continuing to use under these conditions may result in fire or leak which could cause a fire, injury, and corrode the product.
Epson shall not be responsible for the loss of any data, Do not use the product in heavy rain. damage to data, or loss of profits that occurs at such a time.
Part Names and Functions Headset Camera Lens justifier Captures images and movies. Remove the protective film before You can adjust the position of the lens vertically. Make sure the using the camera. You can adjust the direction of the camera lens is level when adjusting.
Controller The illustrations show the controller when it has been removed from the controller holder. micro USB port Cross-key You can connect a commercially available USB cable to connect Highlights items and moves the cursor when making settings or to a computer. operating an application.
Getting Ready Charging the Battery Replacing with Optional Batteries Make sure you charge the product when using it for the first time. This section explains how to replace a battery with a fully charged Initial charging takes approximately three hours. battery.
Replacing the Inner Pad Install the charged battery. The inner pad B is attached to the headset at the time of purchase. If the headset feels tight, replace this with inner pad A or C. The Align the charging connectors on the battery with those on headset feels loose if you attach a smaller inner pad.
Turning On and Off Wearing the Product Note Wearing the Controller Before turning on the product, check that the battery is charged. ➡ “Charging the Battery” p. 8 This section explains how to wear the controller on your arm using the armband.
Wearing the Headset Tighten the head band and secure the head pad. Wear the headset so that you can view your surroundings when you slide up the lens. When not viewing images, make sure you slide up Put on the headset from the top. the lens for your own safety.
Viewing Images Using the Headset Maintenance When you turn on the product, you can view images through the Cleaning the Headset lens approximately 4 m away from you. • If you can see marks in the image or if the image is hazy, check that there is no dust, fingerprints, and other dirt on the lens.
Troubleshooting If you think a malfunction has occurred, check the following. The product does not turn on Cannot use the controller • Check that the batteries are installed in the controller correctly. • You cannot perform controller operations when the key lock indica- •...
Capacitor microphone Sensors GPS/geomagnetic sensor/IMU (accelerometer/gyroscopic sensor)/illumination sensor Bluetooth 3.0 HSP/A2DP/HID/OPP/SPP/AVRCP Bluetooth 4.0 LE *2 PXP/FMP *1 :Restrictions in operation may occur when using an adapter plug. *2 :You can only connect to a beacon with devices specified by Epson.
2. We provide the source code of some open source software programs. If you desire to receive the source code above, please see the "http://www.epson.
Cet appareil avec l’appareil W-LAN a été testé aux SAR et est conforme aux exigences des FCC et IC exposition pour les appareils portables. Le test SAR a été fait à distance de 0 cm du corps. Indication of the manufacturer and the importer in accordance with requirements of directive 2011/65/EU (RoHS) Manufacturer: SEIKO EPSON CORPORATION Address: 3-5, Owa 3-chome, Suwa-shi, Nagano-ken 392-8502 Japan Telephone: 81-266-52-3131 http://www.epson.com/...
In France, WLAN usage is only permitted indoors. DECLARATION of CON- The purpose of the WLAN function is to connect to a 2.4 GHz access point. FORMITY...
A more up-to-date contact address can be obtained from the corresponding website listed here. If you do not find what you need on any of these pages, please visit the main Epson home page at www.epson.com. EUROPE, MIDDLE EAST & AFRICA...
NORTH, CENTRAL AMERICA & CARIBBEAN ISLANDS CANADA COSTA RICA MEXICO ECUADOR Epson Canada, Ltd. Epson Costa Rica, S.A. Epson Mexico, S.A. de C.V. Epson Ecuador http://www.epson.ca http://www.epson.co.cr http://www.epson.com.mx http://www.epson.com.ec U. S. A. Epson America, Inc. http://www.epson.com SOUTH AMERICA ARGENTINA BRAZIL...