Table of Contents
Advertisement
WARNING
• When in Stationary Mode, it is possible that the faster
vehicle is not traveling in the same direction as the
strongest vehicle .
5.7 Lock a Speed
The LOCK button transfers the target speed in the TARGET window
to the LOCKED window . After locking the speed, the radar unit
continues to process speeds and display target speeds in the TARGET
window, which will be solely the strongest reflected signal .
Clear a locked speed one of the following ways:
• Press the LOCK button when an antenna is transmitting and no
target is present .
• Change the operating mode .
• Turn the antenna off then on again .
• The locked speed will remain when you change a dual-
antenna transmission status from front to rear or rear to
front .
• You may use the lock feature even when the radar is in
Faster mode .
5.8 Range Setting
You can adjust the range (sensitivity) of the Genesis II Select
Directional in each of the three operating modes independently:
• Moving Opposite Mode
• Moving Same Lane Mode [OPT]
• Stationary Modes
32
The five LED lights above the word RANGE indicate the target-
acquisition range .
Press the negative (–) or positive (+) side of the RANGE button to
decrease or increase the range setting . The range lights progressively
illuminate as you increase the distance . When all lights are on, the
unit is in maximum range . The range setting for each operating mode
will be remembered when the radar is powered off .
5.9 Stopwatch Operation Mode [OPT]
Calculate target speeds without transmitting a radar signal by
using the stopwatch mode . The stopwatch mode relies on the
time/distance formula to calculate target speeds by measuring the
amount of time a motor vehicle takes to travel a known distance .
To place the radar into stopwatch mode, first ensure that no antenna
is currently selected, then press and hold the OPTN button for two
seconds . The MODE window should display "StpW" to indicate you
have activated the stopwatch functions .
The three numeric windows display time, distance, and speed .
25/Aug/2010
SPEED = DISTANCE / TIME
Figure 5.9
The Mode window will display "StpW" whenever the Genesis II Select
is operating in the Stopwatch Mode
TARGET WINDOW
Calculated Speed in km/h
LOCKED WINDOW
Time in Tenths of Seconds
PATROL WINDOW
Distance in Meters
25/Aug/2010
33
Hide quick links:
Advertisement
Table of Contents
