Automatically Setting The Remote Control - Philips SBCRU254/00H Instructions For Use Manual

RU254.qxd 04-06-2004 16:56 Pagina 6
Instructions for use

Automatically setting the remote control

If you cannot find the right code for your brand device, the remote control
can automatically search for the right code.
Example of TV:
1
Make sure the TV is switched on and select a channel using the original
remote control or the keys on the TV (for example channel 1).
The RU254 emits the 'switch off TV' signal for all models of TV that are
stored in the memory.
• If the device is a DVD-player or video recorder,
insert a disk or tape and start playback.
2
Then keep keys 1 and 3 on the RU254
pressed simultaneously for three seconds, until
the green indicator light remains lit.
3
Press the Standby key of the RU254 briefly.
– The RU254 now starts emitting all known 'TV off ' signals, one by one.
Each time a code is sent, the green indicator
light flashes.
4
When your TV switches off (stand-by),
you press the Standby key of the RU254
twice within 1 second, to confirm.
– The RU254 has now found a code that works
on your TV.
5
Check if you can operate all functions on your TV with the RU254.
• If this is not the case, you can redo the automatic setting.The
RU254 will then search for a code that perhaps works better.
– After the RU254 has run through all the known codes, the search will
stop automatically and the green light will stop flashing.
– Automatic programming takes a maximum of 8 minutes for TV,
4 minutes for VCR, 5 minutes for SAT and 4 minutes for DVD.
6