Automatically Setting The Remote Control - Philips SBC RU 151 Instructions For Use Manual

RU151.qxd 04-06-2004 16:51 Pagina 6
Instructions for use

Automatically setting the remote control

If you cannot find the right code for your brand device, the remote control
can automatically search for the right code.
1
Make sure the TV is switched on and select a channel using the original
remote control or the keys on the TV (for example channel 1).
The RU151 emits the 'switch off TV' signal for all models of TV that are
stored in the memory.
2
Then keep keys s and y on the RU151
pressed simultaneously for five seconds, until
the green LED remains lit.
3
Press the Standby key of the RU151 briefly.
– The RU151 now starts emitting all known
'TV off ' signals, one by one.
Each time a code is sent, the green LED
will flash.
4
When your TV switches off (stand-by),
you press the Standby key of the RU151
twice within 1 second, to confirm.
– The RU151 has now found a code that works on your TV.
5
Check if you can operate all functions on your TV with the RU151.
• If this is not the case, you can redo the automatic setting.
The RU151 will then search for a code that perhaps works
better.
– After the RU151 has run through all the known codes,
the search will stop automatically and the green LED will stop flashing.
– Automatic programming of a TV takes a maximum of 5 minutes.
6