Setting The Remote Control - Philips SBCRU254/00H Instructions For Use Manual

RU254.qxd 04-06-2004 16:56 Pagina 5

Setting the remote control

This is only necessary if your appliance does not respond to the RU254.
If that is the case, the RU254 does not recognize the brand and/or model of
your appliance and you need to program the remote control to do so.
The example below (TV) instructs you how to do this.You can repeat the
same steps for other appliances (DVD, video recorder, etc.) which you want
to operate using the RU254.
Example of TV:
1
Turn on the TV manually or use the original remote control.
Tune in to channel 1.
2
Look up the brand of your TV in the code list at the back of this
manual. One or more four-figure codes are shown for each brand.
Note the first code.
Be careful! There are separate tables for TV, video, DVD, etc.
Make sure you use the codes from the correct table.
3
Press the RU254's TV key to select TV.
(See 'Testing the remote control'.)
4
Keep keys '1' and '3' pressed simultaneously
for three seconds until the green indicator
light remains lit.
5
Then enter the code noted in step 2 using
the digital keys.
– The green indicator light will now flash twice.
If the light flashes once for an extended
period, the code has not been entered
properly or the wrong code has been
entered.
Start again from step 2.
6
Point the RU254 at the TV and check that it responds as it should.
– If the TV responds to all of the key commands, the RU254 is ready for
use. Do not forget to note your code.
• If the device does not respond at all, or not to all of the
key commands, start again from step 2 and try the next code
from the list.
Instructions for use
5