Advertisement
INSTALLATION PROCEDURE (For wall mounting only)
Mounting holes
Fig. 1
Cover
retaining
screws
LAMP FAULT
BATT. FAULT
indicator
TEST
button
Fig. 3
1. Use the supplied mounting accessories to mount the device (Fig1).
2. Remove the four cover retaining screws (Fig 1).
3. Install the battery cable connectors to the batteries taking care of the polarity, black cable (-)
and red cable (+).
4. Always use in any case round mains cable, with external diameter of 6-9mm (H05RN-F
type 2x1mm² or any other type, at least equal to it's mechanical and electrical properties).
ATTENTION!! The cable must not be deformed in any way (This requirement is important
to ensure the tightness isolation IP65). Install the cable gland and pass the round cable.
Connect the cables to the respective positions in the terminal block L for phase and N for
neutral (Fig 2).
5. If you use a module, open a hole from the other side of the luminaire (Fig.3). Install the cable
grommet and pass the 2 signal cables on the C,NO terminal (Fig. 4), minding the correct
polarity. Depending on the module that will be used, the cables, have different names. In
signal +L, A are also connected, while signals -L, B in the terminal NO (Fig.4).
6. Reinstall the front cover and fasten the retaining screws. (Tightening torque 1Nm).
Pay attention to the 4 sealing o-rings.
WARNING!!
After the installation has finished, charge the batteries for at least 24 hours so as to obtain
the rated autonomy duration.
Page 3 from 4
POWER
CHARGE
indicator
5
Fig.2
4
3
Fig.4
L
N
Module
position
5
C,
923037006_09_006
Advertisement
