Par2 Mode - Program Version And Reset - DK System DK LOGIC 200 Manual

19. PAr1 mode - a parameter visible on a main screen (cont.)
2. One of the following symbols will appear on the
screen: C - means that the time will be seen on
a main screen; t - means that the temperature
will be seen on a main screen. Choose the
required option by pressing the "-/+" buttons
and by confirming with
controller will switch to the main screen view.

20. PAr2 mode - program version and RESET

PAr2 - shows the program version installed in the controller. Additionally, in this
mode, it is possible to reset all the settings of the thermostat.
1. Press the
symbol appears. Confirm by pressing
2. A number of the installed program, e.g. 10.04
will appear on the screen. Pressing the button
will cause the controller to switch to the
main screen view.
20.1 RESET
If necessary, it is possible to reset all the settings, returning to the factory
controller. To do this:
1. Go to the view of the program number.
2. Press and hold the "-" button for a few seconds;
RES will appear on the screen, and after a while
the controller will switch to the main screen
view - it will be working on the factory (default)
settings, realizing the Pr1 program.
Wireless room thermostat DK LOGIC 200
after a while, the
button for a few times till the PAr2
.
t
17