Example - Programming The Automatic Operation Mode - DK System DK LOGIC 200 Manual

13.2 Programme Pr.3 - user settings (cont.)
2. Use the "-/+" to choose a day (range of days) to
be programmed (acc. to the matching above)
and confirm with
displayed on a screen (and in the same manner
for all remaining programmes, in line with the
matching above), next, an hour will be
displayed for which a start of the first day or
night temperature ranges in a given day must
be determined.
3. Use the "-/+" buttons to set the hour when the
first temperature range starts, and the buttons
. to check what temperature - comfort (day)
or lowered (night) is about to start at a given
hour - a corresponding symbol
(Moon) will be displayed on a right side of the
screen.
4. Confirm the settings by pressing
of another temperature range in a given day will
be displayed on a screen (e.g. 1:U2), and then
the hour when it should start - the setting is
carried out as described above.
5. All the remaining temperature ranges are being
set in the same way.
6. Once the settings are done, press
until the main scree is shown.

13.3 Example - programming the automatic operation mode

A thermostat will be programmed for the entire
week between 6 - 9 and 16 - 21 and a daily tempe-
rature of 22°C will be set; for the remaining period
of the day, a lowered temperature of 17°C, as per
the diagram below, will be set.
12
Wireless room thermostat DK LOGIC 200
. For d:1, 1:U1 will be
t
(Sun) or
t
PROG
PROG
PROG
.
PROG
; A symbol
PROG
PROG
twice
AUTO
°C
22
17
6 9 16 21 hours