DeWalt DW076 Instructions Manual page 32

E N G L I S H
Make sure the protective cap is in place
before storing or carrying a detached
battery pack.
Equalization mode
The equalization mode helps to
maintain the optimum capacity of the
battery pack. It is therefore
recommended to use the equalization
mode weekly or every 10 charge/
discharge cycles.
• Charge the battery pack as described above.
• When the charging indicator stops blinking, leave
the battery in the charger for approx. 4 hours.
Hot Pack Delay
When the charger detects a battery that is hot, it
automatically starts a Hot Pack Delay, suspending
charging until the battery has cooled. After the battery
has cooled, the charger automatically switches to
the pack charging mode. This feature ensures
maximum battery life. The red indicator (7) blinks
long, then short while in the Hot Pack Delay mode.
Low battery indicator (fig C1)
The tool has been equipped with a low battery
indicator (8) located on the control panel. The low
battery indicator is lit while the tool is switched on.
It will blink to indicate that the battery pack needs to
be recharged and the tool will automatically shut down.
• Switch off the tool and take out the battery pack
(4) to charge it as soon as the indicator blinks.
The tool remains non-operational as long
as a low battery pack is attached to it.
Battery type (fig. C3 & C4)
The tool is suitable for battery packs with different
voltages.
• To fit battery packs of 18 volt, rotate the adapter
plate (13) into position A.
• To fit battery packs of 9.6, 12 or 14.4 volt,
rotate the adapter plate (13) into position B.
Refer to the table in the back for a selection of
applicable battery packs.
32
Setting up the tool (fig. D1 & D2)
The tool facilitates various set-ups, making it useful
for several applications.
Floor set-up (fig. D1)
• Place the tool on a relatively smooth and level
surface.
• Adjust the tool for a level application.
Tripod set-up (fig. D2)
The tool has been equipped with a tripod receptacle
for mounting to the DE0735/DE0736 tripod (optional)
or any other tripod with the required ratings stated in
the technical data.
• Place the tripod (14) on a relatively smooth and
level surface.
• Mount the tool to the tripod by turning the
threaded pin (15) into the receptacle (16) in the
base.
• Adjust the tool for a level application.
Adjusting the tool (fig. A)
• Place the tool into the required position as shown.
• To initiate the leveling procedure, switch on the
tool. The leveling procedure is indicated by the
flashing of the leveling indicators (9 & 10) and the
laser beam. Once the tool has found its level
position the leveling indicators and the laser
beam will stop flashing and remain on.
• The leveling indicators and the laser beam
repeatedly flash three times rapidly to indicate
that the tool has been set up at a slope that is
beyond the self-leveling range of 5°. Switch the
tool off, re-adjust the tool set-up within the self-
leveling range and switch the tool on again.
Aligning the laser line (fig. E1 & E2)
• With the tool switched on and the laser head
rotating, align the laser line with the position mark.
• If adjustment is required, proceed as follows:
With tool in floor set-up (fig. E1):
• The tool can be placed on any sturdy object to
obtain the required height.
With tool in tripod set-up (fig. E2):
• Adjust the tripod to set the tool to the required
height.