The Wind Screen; To Use Cst To Flash The Headset - Husqvarna X-COM R Workshop Manual

7.12 The wind screen

7.12.1 To disassemble the wind screen
1. Remove the O-ring (A).
2. Remove the wind screen (B) from the boom
microphone (C).
7.12.2 To assemble the wind screen
1. Assemble the wind screen (B) to the boom
microphone (C).
2. Assemble the O-ring (A) to the wind screen.

7.13 To use CST to flash the headset

Note: Make sure that the headset is charged to a
minimum of 50% or connect the charger cable.
1. Connect the charger cable to the left earmuff. Wait
for the beep sound to make sure that the headset
charges.
2. Connect the cable (A) (USB to TTL Serial Cable) to
the your computer.
3. Start the CST software on your computer.
893 - 001 -
A
B
C
B
A
C
4. Choose the correct product in the drop down menu
"Product category".
Searching for product...
Is your product connected?
BluetoothHeadphoneConnection
Product category
5. Press the forward button when you connect the
cable (A) to the phone jack (B).
6. Refer to the CST instructions to flash the headset.
>
B
A
Repair instructions - 23