Husqvarna X-COM R Workshop Manual page 18

3. Remove the loudspeaker (A) from the circuit board.
4. Disconnect the the loudspeaker cables from the
circuit board.
18 - Repair instructions
7.8.2 To assemble the loudspeaker
A
1. Right earmuff: Assemble the loudspeaker on the
circuit board according to the illustration. Connect
the loudspeaker cable to position B. Put the cable
(C) according to the illustration.
2. Left earmuff: Assemble the loudspeaker on the
circuit board according to the illustration. Connect
the loudspeaker cable to position D. Put the cable
(E) according to the illustration.
3. Assemble the right earmuff. Refer to
the right earmuff on page 14 .
4. Assemble the left earmuff. Refer to
left earmuff on page 15 .
CAUTION: Make sure that the wires are not
damaged when you assemble the loudspeaker.
C
B
E
D
To assemble
To assemble the
893 - 001 -