Enabling And Disabling Parksense - Dodge CHARGER 2020 Owner's Manual

192 STARTING AND OPERATING
The vehicle is close to the obstacle when the warning display shows one flashing arc and sounds a continuous tone. The following chart shows the
warning alert operation when the system is detecting an obstacle:
Greater than
Rear Distance
79 inches
(inches/cm)
(200 cm)
Audible Alert
None
Chime
Arc — Left Rear None
Arc — Center
None
Rear
Arc — Right Rear None
Radio Volume
No
Reduced

Enabling And Disabling ParkSense

ParkSense can be enabled and disabled with
the ParkSense switch, located on the switch
panel below the Uconnect display.
When the ParkSense switch is pushed
to disable the system, the instrument
cluster will display the "ParkSense
Off" message for approximately five
WARNING ALERTS
79-59 inches 59-47 inches
(200-150 cm) (150-120 cm)
Single 1/2-
Slow
Second Tone
(for rear center
(for rear center
only)
only)
None None
6th Solid 5th Solid
None None
Yes Yes
seconds. When the gear selector is moved to
REVERSE and the system is disabled, the
instrument cluster display will display the
"ParkSense Off" message for as long as the
vehicle is in REVERSE.
Refer to "Instrument Cluster Display" in
"Getting To Know Your Instrument Panel" for
further information.
47-39 inches 39-25 inches
(120-100 cm) (100-65 cm)
Slow Fast
(for rear center (for rear center
only) only)
None None
4th Solid 3rd Flashing
None None
Yes Yes
The ParkSense switch LED will be on when
ParkSense is disabled or defective. The
ParkSense switch LED will be off when the
system is enabled. If the ParkSense switch is
pushed and the system is disabled or requires
service, the ParkSense switch LED will blink
momentarily and then the LED will be on.
Less than
25-12 inches
12 inches
(65-30 cm)
(30 cm)
Fast Continuous
2nd Flashing 1st Flashing
2nd Flashing 1st Flashing
2nd Flashing 1st Flashing
Yes Yes