To Activate/Deactivate; To Set A Desired Acc Speed - Dodge CHARGER 2020 Owner's Manual

When the vehicle speed is outside of the

speed range.
When the brakes are overheated.

When the driver's door is open at low speeds.

When the driver's seat belt is unbuckled at

low speeds.
Electronic Stability Control (ESC) Full Off

mode is active.

To Activate/Deactivate

Push and release the Adaptive Cruise Control
(ACC) on/off button. The ACC menu in the
instrument cluster displays "ACC Ready."
Adaptive Cruise Control Ready
To turn the system off, push and release the
Adaptive Cruise Control (ACC) on/off button
again. At this time, the system will turn off and
the instrument cluster displays "Adaptive Cruise
Control (ACC) Off."
Adaptive Cruise Control Off
WARNING!
Leaving the Adaptive Cruise Control (ACC)
system on when not in use is dangerous. You
could accidentally set the system or cause it
to go faster than you want. You could lose
control and have a collision. Always leave the
system off when you are not using it.
STARTING AND OPERATING

To Set A Desired ACC Speed

When the vehicle reaches the speed desired,
push the SET (+) button or the SET (-) button
and release. The instrument cluster display will
display the set speed.
If the system is set when the vehicle speed is
below 20 mph (32 km/h), the set speed shall
be defaulted to 20 mph (32 km/h). If the
system is set when the vehicle speed is above
20 mph (32 km/h), the set speed shall be the
current speed of the vehicle.
NOTE:
ACC cannot be set if there is a stationary vehicle
in front of your vehicle in close proximity.
Remove your foot from the accelerator pedal. If
you do not, the vehicle may continue to
accelerate beyond the set speed. If this occurs:
The message "DRIVER OVERRIDE" will

display in the instrument cluster display.
The system will not be controlling the

distance between your vehicle and the
vehicle ahead. The vehicle speed will only be
determined by the position of the accelerator
pedal.
179
5