Fluigent LineUp Series Quick Start Manual page 8

Push-Pull specificities
Push-Pull
The
except that it can output
and vacuum
Push-Pull output (mbar)
To do so, it needs
supply of the
connector located
"unlock" handle.
Vacuum
supply inlet
Pressure /
Vacuum outlet
Note : Depending on the supply pressures, the performance of
the module can vary, especially for the vacuum pressure supply.
When connecting the two supplies, only the positive pressure supply
will be checked on the "Inlet pressure check window". (see page 10)
8
module works the same way as other
pressure
(below atmospheric pressure)
1000
-800
two inlets: the positive one, uses the
Flow EZ , and the negative one, utilizes an
TM
at the front between the
QUICK START GUIDE
Flow EZ
(above atmospheric pressure)
through the same
Required pressure supply (mbar)
1100
-800
standard pressure
FLOW UNIT
Special
should be taken to
prevent liquid from
flowing back into
the module.
Positive pressure
supply inlet
modules,
TM
port.
additional
port and the
attention