Table of Contents
Advertisement
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Steamfast SF-623
Summary of Contents for Steamfast SF-623
- Page 1 Mid-Size Fabric Steam Press Owner’s Guide Guía Del Propietario De La Plancha A Vapor Para Tela De Medio Porte Guide D’utilisation – Presse À Vapeur Pour Tissu De Taille Moyenne MODEL SF-623 ENGLISH p. 2 MODELO SF-623 ESPAÑOL p. 14 ENGLISH | 1 MODÉLE SF-623...
-
Page 2: Important Safety Instructions
8. Do not operate unit with a damaged power cord or if the unit has been dropped or damaged. To avoid risk of electrical shock, do not disassemble unit or attempt to repair the appliance; contact Steamfast Consumer Service for examination and repair. Incorrect reassembly can cause a risk of electrical shock when unit is used. - Page 3 If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to contact Steamfast Consumer Service at 1-800-711-6617. Please refer to our website for the most current version of our owner’s guide.
-
Page 4: Product Information
Product Information The following features and accessories are included with your steam press. Carefully inspect packaging material as some parts are shipped inside Styrofoam packaging. To obtain possible missing parts, refer to the Consumer Support section on page 10 of this manual. 9a(9b) UNIT FEATURES &... - Page 5 • The Handle (1) is used to safely lift up and lower the Pressing Plate, and carry the unit. • The Steam Burst Buttons (2) are located on either side of the Handle, and produce a powerful burst of steam when pressed. •...
-
Page 6: Operation
Using Your Mid-Size Fabric Steam Press FILLING WATER RESERVOIR 1. Place Mid-Size Fabric Steam Press on a flat, level surface. 2. Turn Locking Knob to “Unlock” position to unlock Pressing Plate. 3. Lift up Pressing Plate using Handle. It will automatically stay in lifted position. 4. - Page 7 STEAM BURST 1. Hold Pressing Plate approximately 3 in. (75 mm.) above Ironing Board. 2. Press Steam Burst Button to release a burst of steam onto fabric for 2-3 seconds. 3. Lower Pressing Plate onto fabric for 8-10 seconds, then raise once again. Note: If press is left on fabric for more than 10 seconds, it could result in damage to fabric.
-
Page 8: Storage & Care
Storage & Care AUTO SHUT-OFF The Auto Shut-Off feature deactivates electrical power to the heater when the Pressing Plate has been left in closed position against the Ironing Board. The Pressing Indicator Light (Orange) and Steam Burst Ready Indicator Light (Orange) does not illuminate. Heater functionality is restored when the Pressing Plate is lifted back up. -
Page 9: Troubleshooting
Troubleshooting PROBLEM POSSIBLE CAUSE SOLUTION Unit fails to heat up and steam. Unit is not plugged in. Plug into electrical outlet. Power Indicator Light does Household Circuit Breaker/ Reset Circuit Breaker/Ground not illuminate. Ground Fault Interrupter has Fault Interrupter, or replace fuse. tripped or blown a fuse. -
Page 10: Product Support
For problems with your Fabric Steam Press, please refer to the troubleshooting guide located on Page 9 of this manual. Additional inquiries should be directed to our consumer support services through our Web site, www.steamfast.com. If you do not have internet access, you may also contact our Consumer Service Department by telephone, at 1-800-711-6617. -
Page 11: Accessories And Parts
When ordering accessories and parts for your Fabric Steam Press, you may refer to the part numbers below. Replacement parts may be ordered through our Web site: www.steamfast.com You may also contact Consumer Service directly: consumerservice@steamfast.com or 1-800-711-6617 PRESSING CUSHION SPRAY BOTTLE FUNNEL... -
Page 12: Warranty Information
Owner’s Guide (the “Warranty Period”). In the event Buyer notifies Steamfast of a defect in the Product within the Warranty Period, Steamfast will replace the Product and/ or defective component parts, as applicable and necessary. Any such replacement will be made... - Page 13 All such fees and costs shall be the sole responsibility of Buyer. Please allow at least 1-2 weeks for return of the Product after it is received by Steamfast. For ease of recordkeeping, it is recommended that Buyer staple or attached the original sales receipt to this Owner’s Guide and record the Product serial number (located on the Product specifications...
- Page 14 évaluer ce produit en ligne www.steamfast.com/reviews Steamfast 415 East 13th Street, Andover, KS 67002 1-800-711-6617 www.steamfast.com consumerservice@steamfast.com T623-005 R-, V01...
Need help?
Do you have a question about the SF-623 and is the answer not in the manual?
Questions and answers