Setup Procedure - ELECTROCOMPANIET ECM 1 MKII Owner's Manual

Unpacking the ECM 1 MKII
Immediately upon receipt of the ECM 1 MKII, inspect the carton for possible damage
during shipment. The carton and packaging have been designed to provide the
safest possible protection for transport of your network music player. Unpack the
unit carefully. Save all packaging materials for future shipment.
The contents of the carton
• 1 pc. Electrocompaniet ECM 1 MKII Network Music Player.
• 1 pc. AC main cord.
• 1 pc. Inspection card.
• 1 pc. Owner's manual.
• 1 pc. IR Remote control.
Set up procedure
Before connecting the ECM 1 MKII to the AC Power outlet, check that the main volt-
age selector on the rear panel corresponds to the line voltage in the country were you
intend to use the unit. (See illustration "rear panel", page 5.)
How to avoid damages
Do not under any circumstances connect or disconnect equipment when power is
turned on. The design of the RCA plug generates a huge transient when inserted.
Connecting or disconnecting equipment with the power on can result in severe
damage to both speakers and amplifier.
How to avoid noise problems
The ECM 1 MKII contains delicate circuits that are sensitive to magnetic stray fields.
The unit should not be placed near power voltage transformers, TV sets etc. Care
should also be taken regarding placement of the interconnect cables. Do not run
interconnect cables in parallel with main cords or speaker cables. Keep interconnect
cables as short as possible.
How to avoid possible antenna problems
In some set-ups hum may occur when you connect the radio, VCR or TV to your
system. The problem is caused by DC voltage offset coming from your antenna system.
Please contact your cable network operator.
3