User Interface & Brewing Procedure; Priming The Brewer - Keurig B3000 Service Manual

6. User Interface & Brewing Procedure (Without a coin changer)
IMPORTANT: The brewer must be primed for its first use as set forth below. If Spanish or
French are going to be the primary language, then you must go to the MENU MODE (page 19)
and change the language before proceeding with the priming of the brewer. The brewer's default
language is English.
NOTE: The B3000 power switch uses "0" for OFF and "

Priming the Brewer

1. Place a cup or mug (8 oz Min) on the Drip Tray Plate (if not done, the brewer will prompt for the
cup or mug later in the priming sequence)
2. Press power switch to the "
3. At power up, the brewer will display the following:
4. The display will automatically change to:
5. After water is connected, then press button.
6. The display will read:
7. Then automatically change to:
8. After heating has taken place the display will read:
9. After placing the cup the screen will read:
10. Press the flashing button and conduct a water only brew.
11. After the water only brew is complete the unit is primed and the following will be displayed:
12. Next you will read:
13. After heating has taken place the screen will show:
-
" position.
KEURIG B3000 BREWING SYSTEM
CONNECT WATER AND THEN PRESS FLASHING BUTTON
HEATING - PLEASE WAIT
PLACE YOUR CUP
OR SELECT ' CONT '
PRESS FLASHING BUTTON
TO CONTINUE
PRIME COMPLETE
HEATING – PLEASE WAIT
READY – CHOOSE K-CUP
LIFT HANDLE
B3000 SERVICE MANUAL
60-200807-000, REV C
-
" for ON.
PRIMING
PRIMING
(With a Coin Changer)
READY
DEPOSIT XXX CENT
15