General Operation - Volkswagen RMT200 User Handbook Manual

BDA 051 228 A BA Radio RMT 200.book Seite 108 Freitag, 20. Juli 2012 12:21 12

General operation

Switching on, off or mute
The device is switched on by briefly pressing the rotary knob
when inserting the button of the vehicle. The last audio source is played back in the previously set volume
as long as this does not exceed the maximum previously set switching on volume
By briefly pressing the rotary knob
("MUTE"). Press the button again to cancel the mute function.
The device is switched off manually by pressing the rotary knob
turning off the vehicle ignition or when removing the button of the vehicle.
Audio source selection
By repeatedly pressing the
the sequence of FM1, FM2, MW1/AM1
the selection begins again with FM1.
Data carriers are only indicated if a data carrier has been inserted or a respective device has been
connected.
If a CD or an SD card has been inserted or a device connected to the USB or AUX socket, the playback
starts automatically.
MODE
Keeping the button pressed starts the audio source BT AUDIO
Audio settings
The respective values are shown in the display during the setting. If rotary knob
few seconds then the current setting is saved and the device exits the menu automatically.
Playback volume
1
Turn the rotary knob
During the setting, the value "VOL 01...31" or "VOL MIN" or "VOL MAX" are shown in the display.
Sound and volume settings
Sound and volume settings are set and saved for each of the audio sources during the data carrier
playback, AUX mode and when operating the radio.
MENU
By pressing the button once, the menu EQ SET is called up. In this menu, the pre-defined
sound settings POP, ROCK, CLAS or JAZZ can be selected by pressing the corresponding function
button.
By pressing the function button
your own settings for sound (BASS, TREB, MID) und for the volume (BAL, FAD, S_VOL).
Function button Setting
BASS
low frequencies (Bass)
TREB
high frequencies (Treble)
MID
medium frequencies (Middle)
BAL
volume distribution left and right
FAD
volume distribution front and rear
S VOL
maximum switching on volume
Press the desired function button and perform the settings using the rotary knob
3)
Depending on the AREA selected (
MW or AM.
108
1
of the device switched on, you can temporarily switch on the mute
MODE
button, you are able to switch through the available audio sources
3) 3)
, MW2/AM2 , CD, USB/IPOD, SD or AUX. After an initial run,
to the left to reduce the volume or to the right to increase the volume.
USER
the corresponding sub-menu is called up and you can make
Page 111), the frequency range medium wave can be shown in the display as
1 or by turning on the vehicle ignition or
S VOL
1
for a long time or automatically by
Page 120.
1
is not pressed for a
1
.
(see below).